مناسب لجميع أنظمة التبريد والتدفئة.
متوافق مع جميع مثبتات التبريد القياسية ومضادات التجمد.
1 لتر يكفي لما يصل إلى 50 لترًا من سائل التبريد.
للمحترفين فقط!
تشكل الرواسب في نظام التبريد/التدفئة حواجز ضد التبادل الحراري، مما يعيق منظم الحرارة وآليات التنظيم.
مناسب لجميع أنظمة مياه التبريد في السيارات والحافلات والمركبات التجارية.
أضف المحتويات إلى ماء التبريد.
قم بتشغيل نظام التدفئة.
اعتمادًا على درجة التلوث، دع المحرك يعمل لمدة تتراوح من 10 إلى 30 دقيقة تقريبًا.
قم بتصريف المنظف وشطف نظام التبريد بالماء
Deposits in the cooling/heating system create blockages for heat exchange and they also block thermostat valves and control mechanisms. When engine temperatures are too high, the engine runs uneconomically and suffers excessive wear at considerable risk of damage. This concentrate safely removes deposits containing oil and lime and ensures that the engine runs reliably and at the optimum temperature. Does not contain aggressive acids or alkalis. For all coolant and heating systems. Compatible with all commonly used cooling water refiners and antifreezes. 1 l is sufficient for up to 50 l of coolant.
Application
Add contents to the coolant and start up the heater.
Depending on the level of contamination, run the engine at operating temperature for 10 – 30 minutes.
Drain the cleaner, thoroughly flush out the cooling system with water and fill according to the manufacturer's specifications.
Contents will treat up to 50 liters of coolant.
removes oil and grease-based contaminants
chemical conversion of lime
does not contain acids or alkali
compatible with antifreeze
good material compatibility
neutral behavior on rubber and plastics
neutralizes acids
disperses sludge
Suitable for all cooling and heating systems.
Compatible with all standard cooling stabilisers and anti-freeze.
1 litre is enough for up to 50 litres of coolant.
For professionals only!
Deposits in the cooling/heating system form barriers against heat exchange, blocking the thermostat and regulating mechanisms.
Suitable for all cooling water systems in motor vehicles, buses and commercial vehicles.
Add contents to the cooling water.
Run the heating system.
Depending on the degree of contamination let the engine run approximately 10 to 30 minutes.
Drain the cleaner and flush out the cooling system with water.
